CHALLENGE
Mpact must verify very low concentrations of regulated metals,
including Al, Sb, As, Ba, Cd, Cr, Co, Cu, Eu, Gd, Fe, La, Pb, Li, Mn,
Hg, Ni, Tb and Zn, in accordance with Commission Regulation (EU)
No 10/2011 and its amendments, as well as BfR Recommendation
XXXVI for Paper and Board for Food Contact, which sets specific
limits for Pb, Cd and Al.
At such low concentration levels, contamination control
becomes a critical part of the analytical workflow. Any
residual trace metal left on glassware or laboratory accessories
could affect the results and compromise the laboratory’s ability to
demonstrate that packaging materials comply with the applicable
limits.
Before implementing traceCLEAN, the laboratory relied on a
conventional manual acid-cleaning procedure. Glassware
and accessories had to be soaked for extended periods using
relatively large quantities of concentrated acids, before being
manually removed, rinsed and dried.
This method presented several important challenges. From
a safety perspective, laboratory personnel had to handle
substantial volumes of corrosive acids and work close to potentially
harmful acid vapours. The repeated transfer, rinsing and disposal
steps increased the risk of operator exposure, accidental spills
and contact with hazardous chemicals.